When requsting help with " I D " or locating a part
PLEASE ! ! READ BELOW.
A ) Send a picture of the item with a good description.
B ) The type of wheel IE : Torque Thrust - Slot mag - 200S or ? ? ?
C ) Diameter, width, bolt pattern. That you want to find.
D ) Any script on back side.
* * Center caps are not good for ID purposes.
This will give you back space information
Pic # 13 Measurement starts at the brake drum surface
Measure from brake drum surface to top lip
Pic # 14 You must measure thru the hub to outer lip
Rim width is Bead to Bead
A : The overall diameter of a wheel is measured outside edge across. The wheel size is measured where the tire bead rests.
B : The overall width is the outside and true width is the bead to bead.
C : Back space & front space is figured this way : from brake drum mounting surface to back edge of wheel will give you back and the remainder is front space.
A 14x6 wheel is 7" in true diameter : if you have 3" of back space then you have 4" of front space. ALL measurements mean something when you are trying to put a wheel on your car. Dont forget to add tire bulge to your wheels.
Use this for BOLT patterns outside 2 inside
You can do the same for Center Cap Screw space
Bolt Patterns : There are a number of ways to measure bolt patterns and I find this easy to do .
Measure OUTSIDE to INSIDE using the same meathod as in picture above.
5 on 4"........= 2 6/16"
5 on 4.5" ... = 2 5/8"
5 on 4.75'... = 2 3/4"
5 on 5 "....... = 2 7/8"
5 on 5.5 "... = 3 1/4"